Bosch B9512G - Page 5

Control Panels Table of contents | en 5
Bosch Security Systems, Inc. Installation Manual 2018.07 | 10 | F.01U.303.996
9.1.9 Troubleshooting 62
9.2 Keyswitches 62
9.2.1 Operation 63
9.2.2 Installation and control panel wiring (keyswitches) 63
9.3 RADION keyfobs and Inovonics pendant transmitters 64
10
On-board outputs 65
10.1 Circuit protection 65
10.2 Total available power 65
10.3 Continuous power outputs 66
10.4 Programmable power outputs 66
10.4.1 Terminals 6 and 7 66
10.4.2 Terminal 8 67
10.5 USB power 67
11
Off-board outputs 68
11.1 B308 octo-output module 68
11.1.1 SDI2 address settings 68
11.1.2 Supervision 68
11.1.3 Installation and control panel wiring (B308) 69
11.2 B600 Retrofit ZONEX Module 69
11.2.1 Installation and control panel wiring (B600) 70
11.2.2 D8129 Octo-relay Module 71
12
On-board points 72
12.1 Point sensor loops 72
12.1.1 Single EOL (and no EOL) resistor circuit style 72
12.1.2 Dual EOL resistor circuit style 73
12.2 Point response time 74
13
Off-board points 75
13.1 B208 octo-input module 75
13.1.1 SDI2 address settings 75
13.1.2 Supervision 75
13.1.3 Installation and control panel wiring (B208) 75
13.1.4 Sensor loops overview and wiring 77
13.2 B299 POPEX Module 79
13.2.1 SDI2 address settings 79
13.2.2 Supervision 79
13.2.3 Installation and control panel wiring (B299) 80
13.2.4 POPIT devices overview and wiring 80
13.3 B600 Retrofit ZONEX Module 81
13.3.1 Installation and control panel wiring (B600) 81
13.3.2 D8125 expansion 82
13.3.3 D8128D OctoPOPIT Eight-point Expander 83
13.4 Off-board points test 84
13.5 Extra Point events 84
13.6 Missing point conditions 84
14
Wireless modules 85
14.1 B810 receiver 85
14.1.1 SDI2 address settings 85
14.1.2 Supervision 85
14.1.3 Installation and control panel wiring (B810) 85