Bosch B9512G - B600 Retrofit ZONEX Module; Installation and Control Panel Wiring (B600)

Control Panels Off-board points | en 81
Bosch Security Systems, Inc. Installation Manual 2018.07 | 10 | F.01U.303.996
Wiring the devices
--
+
+
--
+
+
1
(-)
(+)
POPEX
(-)
(+)
2
3
2
5
4
(+)
(-)
-
-
+
+
-
-
+
+
(-)
(+)
Callout ᅳ Description
1 ᅳ B299
2 ᅳ POPIT device
3 ᅳ POPIT address switches
4 ᅳ POPIT sensor loop
5 ᅳ 33 kΩ EOL resistor (P/N: 15-03130-022)
13.3 B600 Retrofit ZONEX Module
The B600 Retrofit (ZONEX) module enables the use of ZONEX devices on the B9512G/
B8512G. The B600 module connects to the control panel through a proprietary connection
(cable provided with module).
The control panel supports one B600.
13.3.1 Installation and control panel wiring (B600)
Calculate power consumption
Make sure that there is enough power for the module and the other powered devices that you
want to connect to the system.
Refer to On-board outputs, page 65.
!
Caution!
Remove all power (AC and battery) before making any connections. Failure to do so might
result in personal injury and/or equipment damage.
Installing the module
1. For retrofit applications, remove the terminal strip from the module.
2. Hold the module mounting brackets onto the inside of the enclosure. Match the bracket
holes to a 3-hole mounting pattern on the enclosure
3. Use the supplied mounting screws to secure the module.