30
Advanced Settings are designed for HVAC professionals
who want to modify advanced features for better unit
control. They also allow you to reset the device to factory
settings.
IP: IP Address
Ability to manually type in IP address
RS: Factory Reset
Factory reset the device to original condition
SC: Sensor Calibration
Calibrate or correct the device temperature readings
IS: Initial Setup
Pull-up Initial Setup screen
WRS: Wi-Fi Factory Reset
Factory reset the Wi-Fi module to original condition
RF: System Backup
Store current firmware in the flash to be used during recovery
HSD: Relative Humidity Hysteresis
Adjust the set point differential for the humidity control
Advanced Features
NOTE: Advanced Settings are for professional use only
and requires access code: 1886.
To Next Page
Loading...
