32 33
Accessory
Use the up and down arrows to change the relative humidity
setpoint, and then press Ok to confirm your selection. You will
see a green check mark confirming your selection.
Note: this item will not appear on your thermostat if you did not
setup a humidifier or dehumidifier accessory during the initial
setup process.
Wi-Fi
Use the up and down arrows to Connect, Re-Connect or
Disconnect from your home’s Wi-Fi network.
Note: When you select Connect, refer to step 17 of the
Installation Guide to add a new device and connect your
thermostat to the Wi-Fi network.
Menu Overview
Schedule
Use the up and down arrows to change the active Schedule.
Note: the schedule can only be programmed from the app.
Menu Overview
Display
u Select Brightness to adjust the screen’s brightness
between high, medium or low.
u Select Timeout to adjust the time before the thermostat
enters idle mode: 20 seconds, 1 minute or 3 minutes.
u Select Idle to enable or disable idle mode. Enabling idle
mode will always display time and Actual Room
Temperature after the timeout period expires.
To Next Page
Loading...
