32 | Operation instructions
C 1210 ES/ESC6 720 644 887 (2013/02)
Fig. 44 Connecting power supply cord
[1] Power cord length: 3ft.
Note: Outlet appliance is plugged in to should be clear from possible
water damage.
5.2 Position of the fuses in control unit
To check fuses, proceed as follows:
▶ Remove the front cover, see fig. 4, page 8.
▶ Remove the three screws from the control unit.
Fig. 45
▶ Remove the six screws from the back cover of the control unit, see fig.
46, pos. 2.
▶ Check the fuses in the printed circuit board, see fig. 46, pos. 3.
Fig. 46 Fuses position
▶ After checking the fuses, reinstall all parts in reverse order.
6 Operation instructions
Fig. 47
[1] On/Off button
[2] Reset button
[3] Program Key
[4] LCD display
[5] Up button
[6] Down button
[7] Power On or stand-by LED
6.1 Description LCD Display
Fig. 48 Power bar indicator (input)
To Next Page
Loading...
