Transporting the boiler
Condens 7000 F – 6720871560 (2019/11)
14
4.2 Lifting the boiler off the pallet
NOTICE:
Boiler damage through impact!
The boiler is at risk of tipping over if it is pushed off the side of the pallet.
Push the boiler off the pallet towards the burner or flue gas side.
Depending on the pushing direction, remove corresponding fixing
strip ( Fig. 7).
Push the boiler of the pallet in the required direction.
Avoid heavy impacts or setting the boiler down too hard.
The boiler is screwed to the pallet via the lower tie bar.
Remove 4 safety screws.
Fig. 7 Detaching the boiler from the pallet (example for illustration
purposes)
[1] Fixing bar on the flue gas side
[2] Fixing strips on the burner side
4.3 Transporting the boiler on rollers
If the path to the boiler room is level, the boiler can also be rolled.
Use at least 5 pipe sections of approx. 700 mm length
(Diameter R 1¼ ") as rollers.
Position the pipes approx. 400 mm apart on the floor.
Lift the boiler onto the pipe sections and carefully transport it to the
installation location.
You can also use commercially available transport rollers.
Fig. 8 Transporting the boiler on rollers (measurements in mm)
Fig. 9 Transporting the boiler on a furniture roller
If the boiler is not to be brought into operation:
Protect boiler from contamination.
Dispose of packaging in an environmentally responsible manner.
0010013512-001
To Next Page
Loading...
