Installation
Condens 7000 F – 6720871560 (2019/11)
16
5.4 Levelling the boiler
NOTICE:
Boiler damage through insufficient load-bearing capacity of the
installation surface or unsuitable substrate!
Ensure that the installation surface offers sufficient load-bearing
capacity.
Level the boiler horizontally to prevent air pockets forming inside the
boiler and to enable condensate to drain fully from the condensation
catch pan.
Bring the boiler into its final position.
Level the boiler horizontally by means of its adjustable feet and a
spirit level.
Fig. 12 Levelling the boiler
5.5 Installing the condensate pipes
DANGER:
Danger to life due to poisoning!
Siphons not filled with water can cause danger to life through escaping
flue gas.
Filling the siphon with water.
Information regarding the condensates pipes:
Carefully drain the condensate created inside the boiler and flue
(route the flue with a slope towards the boiler).
Drain the condensate into the public sewerage system in accordance
with the requirements in your country.
Observe regional regulations.
Install condensate neutraliser (accessory) if necessary.
Fit the condensate hose to the siphon connector using a hose clip.
Guide the condensate hose through the opening in the back panel.
Connect the condensate hose from the siphon with a slope to the
condensate neutraliser.
If required, make the connection to the sewerage system in
accordance with the instructions for the condensate neutraliser and
locally applicable regulations.
Install condensate neutraliser (accessory) in accordance with the
installation instructions.
Fill the siphon below the flue outlet with roughly 3 litres of water.
Fig. 13 Installing the condensate hose
[1] Condensation catch pan
[2] Connecting the condensate hose to the siphon connector
To Next Page
Loading...
