Transporting the boiler
13
Condens 7000 FP – 6721846699 (2022/12)
Open the top flap on the burner controller and unplug the plug
(Fig. 6).
Fig. 6 Unplug the plug from the burner control unit
Loosen the cable on the side and at the top of the supporting plate,
and place on top of the boiler (Fig. 7).
Remove the 6 screws on the supporting plate for the air hose and take
off the supporting plate (Fig. 7, [1+2]).
Unplug both plugs on the differential pressure sensor (Fig. 7, [3]).
Unplug the plug on the solenoid valve (Fig. 7, [4]).
Fig. 7 Loosen the cable and remove the supporting plate
[1] 6x screws
[2] Supporting plate for air hose
[3] Plug on differential pressure sensor
[4] Plug for solenoid valve
Unplug the plug on the fan (Fig. 8).
Fig. 8 Unplug the plug from the fan
Unplug the plug on the ignition transformer (Fig. 9).
Remove the 4 nuts on the mixture manifold / front section (Fig. 9).
Fig. 9 Unplug the plug on the ignition transformer and remove the nuts
on the mixture manifold / front section
[1] Plug on the ignition transformer
[2] Nuts on the mixture manifold
Pull the mixture manifold with burner rod and fan back to the end
position (O-ring on the guide pin)
Remove the mixture manifold with burner rod as described in chapter
11.7 for the Figs. 50 and 51.
Remove the 4 screws on the holding plate of the burner base
(Fig. 10, [2]).
0010041660-001
0010041665-001
1
To Next Page
Loading...
