Bosch Condens 8300i W - Installing the Appliance; Hydraulic Connection

Installation
Condens 8300i W – 6721841531 (2022/10)
18
Fig. 18 Fit mounting rails and connection plate
▶ Fit the pipes with gaskets to the mounting plate.
Fig. 19 Fitting the pipes with gaskets to the mounting plate
6.3.2 Installing the appliance
Removing the casing (see packaging)
▶ Remove the locking bracket.
Hanging the appliance
▶ Fit the sealing washers to service valves.
▶ Hang the appliance.
▶ Unlock the condensate trap and remove from appliance ( Fig.
9.17, p. 46)
▶ Check the positioning of the sealing washers on the pipe
connections.
▶ Tighten the union nuts on the pipe connections starting with the CH
return on the right.
6.4 Hydraulic connection
Preparing the pipework
Residues in the pipework can damage the device.
▶ Purge the pipework prior to connection.
Fitting a pipe to the pressure relief valve
Fig. 20 Fitting a pipe on the pressure relief valve
Connecting the condensate pipes
▶ Insert the condensate pipe hose into the mounting plate (1).
▶ Insert the condensate hose on the connector (2).
Fig. 21 Fitting the condensate pipes to the mounting plate
0010041048-002
0010041049-002
0010041319-001
0010034879-002