Bosch CW 800 - Setting the DHW temperature; Setting the time program for DHW heating

6 720 820 872 (2016/12)CR 400 | CW 400 | CW 800
Service menu | 27
Fig. 17 Overview of the service menu 3/4
3) Only available with DHW system I.
4) Only available with heat source with EMS 2 or with
MM 100/MM 200 module.
Screed drying Cylinder load optimization
3)
Activated Flow temp. increase
Dwell time before start DHW start delay
3)
Start phase duration Start cyl. primary pump
Start phase temperature Min. temp. difference
Heat-up phase step width DHW circ. pump installed
Heat-up phase temp. diff DHW circulation pump
3)
Holding phase duration DHW circ. pump mode
Holding phase temp. Start frequency DHW circ.
Cool-dn phase step wdth Automat. therm. disinfect.
Cool-down phase t.diff Therm. disinfection day
Endphase duration Therm. disinfection time
End phase temperature Therm. disinfection temp.
Max. interruption time Start now manually
Screed dry. system Cancel now manually
Screed dry. H. circ. 1 ... 8 Daily heat-up
Start Daily heat-up temp.
4)
Interrupt Daily heat-up time
4)
Continue Solar settings
DHW settings Solar thermal sys installed
DHW system I ... II Change solar configuration
DHW system I install. (... II...) Current solar configuration
Config. DHW at boiler
3)
Solar parameters
Max. DHW temp. ...
DHW Start solar thermal system
DHW reduced Hybrid settings
Start temp. differential ...
Switch-off temp. diff.
3)
Cascade settings
...
6 720 815 821-103.1O