Bosch CW 800 - Page 56

6 720 820 872 (2016/12) CR 400 | CW 400 | CW 800
56 | Commissioning report
> Heating circuit 1 ... 8
Heating circuit
Menu item Adjustment 1 2 3 4 5 6 7 8
Heating circuit 1
installed
No 
At the boiler  – – – – – – –
At the module 
Ctrl type h. circ. 1 Outdoor-temp.-compensated 
Outside temp. with low end 
Room-temp.-compensated 
Room temperature output 
Constant 
User interface CR400 (no remote control
installed)
 – – – –
CW400 (no remote control
installed)
 – – – –
CW800 (no remote control
installed)

CR100 (remote control installed) 
CR10 (remote control installed) 
Use minimum value Yes 
No 
Heating system heat
circ. 1
Radiator 
Convector heater 
Underfloor 
Set point constant Set temperature
Max. flow temperature Set temperature
Set heating curve Æ Tab. 30
Setback type Reduced mode 
Outside temperature threshold 
Room temperature threshold 
Reduced mode below Set temperature
Heat constantly below Set temperature
Off 
Outdoor temp. Room and outdoor temp. 
Room temperature 
Frost protect 
Off 
Frost prot. limit temp. Set temperature
Table 29 Settings during commissioning in the menu Heating circuit 1 ... 8