-16-
Trouble Shooting
Issue Remedy
Detection tool cannot be switched on
Batteries empty Replace batteries
Batteries incorrectly inserted (wrong polarity) Check if the batteries are inserted correctly
Detection tool switched on but does not react
Take out batteries and reinsert again
Detection tool too warm or too cold
Wait until operating temperature range is reached
Display indication: “Slipping Wheel”
Wheel losing contact with the surface
Press the start button
11
and take care that the two
bottom wheels have contact with the wall while moving
the detection tool; in case of uneven walls, position a thin
piece of cardboard between the wheels and the wall
Display indication: “Speeding”
Detection tool has been moved to quickly
Press the start button
11
and move detection tool
slowly over the wall
“Temperature over range”
Wait until operating temperature
range is reached
“Temperature under range”
Wait until operating temperature
range is reached
“Strong radio signal detected”
Detection tool switches off automatically. If possible,
eliminate the interfering radio waves, e.g. WLAN, UMTS,
radar, transmitter antenna or microwaves, then switch the
detection tool on again.
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
