Bosch D7212GV3 - Installing the Control Panel; Connecting Earth Ground

To Next Page

To Previous Page

D7212GV3 | Program Entry Guide | 2.0 Panel and Area Wide Parameters EN | 15

Bosch Security Systems, Inc. | 10/11 | F01U170808-02

3. To change the configuration, press [ENT] when

the current configuration shows, and then press

[NEXT] or [PREV] to scroll through the options,

as listed in R# Primary Device on page 14.

4. When the keypad reads the desired configuration

option, press [ENT] to select it.

5. When the keypad reads PARAMETER SAVED,

your selection has been configured.

D1260

1. Refer to Figure 2 on page 7 to access Keypad

Programming and navigate to the

Route Group 1 - 4 option.

2. At the Route Group 1 - 4 prompt, enter the route

group number you wish to configure and press

[ENTER]. The keypad reads Rt Group 1

Primary, and then the current configuration (for

example, SDI 88 PATH 4).

3. To change the configuration, press the Edit

softkey, and then press the Next or the Previous

softkey to scroll through the options, as listed in

R# Primary Device on page 14.

4. When the keypad reads the desired configuration

option, press the Save softkey to select it.

When the keypad reads Parameter Saved, your

selection has been configured.

R# Backup Device

Default: No Device

Selection:

No Device, Phone 1..4, SDI ##

Path 1..4

No Device This route group is disabled.

Phone 1 Phone 1 or SDI Path 1 is this

group’s backup destination if the

primary destination fails.

Phone 2 Phone 2 or SDI Path 2 is this

group’s backup destination if the

primary destination fails.

Phone 3 Phone 3 or SDI Path 3 is this

group’s backup destination if the

primary destination fails.

Phone 4 Phone 4 or SDI Path 4 is this

group’s backup destination if the

primary destination fails.

SDI 88 Path 1 Path 1 on SDI 88 is this group's