D7212GV3 | Program Entry Guide | 2.0 Panel and Area Wide Parameters EN | 29
Bosch Security Systems, Inc. | 10/11 | F01U170808-02
Program this item No if it causes false
seizures of the phone line or if you do
not use RPS. This indicates that a
device using the same frequency tone is
also using the phone line to which the
control panel is connected.
If RPS Call Back is programmed Yes,
the control panel hangs up the phone
after the RPS tone and a proper RPS
passcode is identified. It then calls the
RPS phone number.
Answer Armed
Default: Refer to the program record sheet
Selection:
0 to 15
0 No answer.
1 to 15 The control panel answers the phone
after the specified number of rings
when all areas are master armed.
Set the telephone ring counter to answer when all
areas are master armed. If any area in the control
panel is perimeter armed or disarmed, the Answer
Disarmed ring counter is used.
For the purpose of answering the RPS
phone call, the control panel considers
perimeter armed a disarmed state.
Answer Disarmed
Default: Refer to the program record sheet
Selection:
0 to 15
0 No answer.
1 to 15 The control panel answers the phone
after the specified number of rings
when any area in the system is in a
perimeter armed or disarmed state.
Set telephone ring counter to answer when any area
is in a perimeter armed or disarmed state.
For the purpose of answering the RPS
phone call, the control panel considers
perimeter armed a disarmed state.
RPS Phone #
Default: Blank
Selection:
Blank or up to 24 characters
Blank Control panel does not dial a phone
number for RPS.
1 to 24
characters
Enter up to 24 characters to define
dialing characteristics.
This is the phone number the control panel dials to
contact RPS. The control panel dials the
programmed number on Phone #5 (RPS Ph #). The
control panel dials this number when any of the
following events occur:
Log % Full threshold is achieved.
If Log % Full is programmed with a
value (1 to 99) and an RPS phone
number or RPS IP address are
programmed, the control panel attempts
to communicate with Unattended RPS
when the log threshold is reached.
The control panel is contacted by RPS and
RPS Call Back is programmed Yes.
The user enters COMMAND 43 and selects
the call RPS option from the menu. On the
D1255:
1. Press [COMMAND][4][3].
2. Press [NEXT] until RPS Via Phone? appears,
then press [ENTER].
The control panel tries to contact RPS
only once using this method.
Refer to Section 6.5 SDI RPS Parameters on page
113 for other connection methods.
Keypad Programming of RPS PHONE #
D1255
1. Refer to Figure 1 on page 6 to access Keypad
Programming and navigate to the RPS
PARAMETERS option. Press [ENT]. The keypad
shows the RPS PASSCODE option and the
currently configured passcode.
2. Press [NEXT] to advance to the RPS PHONE
NUMBER option.
3. The keypad shows the currently configured
phone number. Press [ENT] to edit the phone
number.
4. The [PREV] button acts as a [Backspace] key.
Press [PREV] to delete the characters of the
phone number, and then enter the new phone
number.
5. Press [ENT] to save the phone number.
To Next Page
Loading...
