D7212GV3 | Program Entry Guide | 1.0 Introduction EN | 5
Bosch Security Systems, Inc. | 10/11 | F01U170808-02
1.0 Introduction
1.1 Using this Program Entry Guide
This guide is only for programming the D7212GV3
Control Panel.
Table 1: Literature References
Document Name Part Number
D1255 Installation Instructions
74-06819-000
D1256/D1257 Installation
Instructions
74-06925-000
D1255RBD1256RBD1257RB
Installation Instructions
F01U011791
D1260 Installation Guide
48101
D1260 Owner’s Manual
50410
Conettix 6600/6100
Receiver/Gateway Program Entry
Guide
4998122702
Conettix central station
receiver/6100 Receiver/Gateway
Computer Interface Manual
4998122703
D720 Installation Instructions
74-06918-000
D7212GV3 Operation and
Installation Guide
F01U143079
D7212GV3 Program Record
Sheet
F01U170810
RPS Installation Guide
4998141259
1.2 Guide to Programming Options
Full configuration of the control panel is only
achieved through use of the Remote Programming
Software (RPS). A limited keypad programmer’s
mode is available to modify some of the more
commonly changed parameters.
This guide is set up in a specific order. Related
program entries are grouped together in modules as
they appear in RPS
The Program Item Prompt: Each prompt is
shown as it appears in the Remote
Programming Software (RPS). Refer to the
RPS Installation Guide (P/N: 4998141259)
Program Entry Default Setting: Because
defaults are set for the typical installation,
programming each prompt might not be
necessary. Review the default entries in the
program record sheet shipped with the
control panel to determine which prompts
must be programmed.
Program Entry Selections: Only the
selections listed can be used for a particular
program item.
Program Entry Description: Describes the
various entry selections. Read the
descriptions carefully to avoid improperly
programmed equipment.
To Next Page
Loading...
