Bosch D7212GV3 - Page 58

D7212GV3 | Program Entry Guide | 2.0 Panel and Area Wide Parameters EN | 58
Bosch Security Systems, Inc. | 10/11 | F01U170808-02
Add User
Default: P
Selection:
-, E, or P
Function
No.
Function Name
Alternate
Keystroke
18 Add User [COMMAND][5][6]
Use this function to add or change passcodes, add or
change tokens or cards and Sub-users, and add or
change control panel authority levels (L##) by area.
Del User
Default: P
Selection:
-, E, or P
Function
No.
Function Name
Alternate
Keystroke
19 Delete User [COMMAND][5][3]
Use this function to delete a user’s passcode and
tokens or cards. It does not delete user names.
This function deletes the passcode,
master user, and all sub-users
associated with the user number.
Extend Close
Default: P
Selection:
-, E, or P
Function
No.
Function Name
Alternate
Keystroke
20 Extend Close [COMMAND][5][1]
Use this function to change the expected closing time
for the area. The window cannot be adjusted until the
Close Early Begin time passes and the Closing
Window is active.
View Log
Default: E
Selection:
-, E, or P
Function
No.
Function Name
Alternate
Keystroke
21 View Log
(Menu function
only)
Use this function to view all of the system events,
their time stamps, User IDs, or point numbers. User
Name and Point Text are not stored in the event log,
but they appear when the control panel matches
them with the User ID ### and the Point ###.
Each event appears on one line in the log. Any
information related to that event appears on a
separate line in the log.
Because events in the log are not uniform in length,
the control panel can store from 500 to 1000 events.
Print Log
Default: P
Selection:
-, E, or P
Function
No.
Function Name
Alternate
Keystroke
22 Print Event Log
(Menu function
only)
Use this function to print all the events stored in the
control panel beginning at the start date and ending
with the last event in the log.
User Cmd 7
Default: P
Selection:
-, E, or P
Function
No.
Function Name
Alternate
Keystroke
23
User COMMAND
7
[COMMAND][7]
Use this function to activate an alarm programmed in
COMMAND 7 in the POINTS > Command 7 /
Command 9 section.