D7212GV3 | Operation and Installation Guide | 13.0 Programmer Connections
.
Bosch Security Systems, Inc. | 10/10 | F01U143079-03 49
The ITS-DX4020-G GPRS/GSM IP Communicator
has two modes; GPRS uses Modem IIIa
2
; and GSM
uses Contact ID.
For programming information refer to the
ITS-DX4020-G GPRS/GSM IP Communicator
Installation and Operation Guide (P/N: F01U163066
).
Figure 22: DX4020 DIP Switch Settings
1 - DIP Switches
2 - ON position
3 - OFF position
4 - SDI Address 80 switch settings
5 - SDI Address 88 switch settings
6 - SDI Address 92 switch settings
12.4.2 Address Settings
The DX4020 has specific DIP switch settings for SDI
Addresses 88 and 92 when using the DX4020 for
Remote Programming Software (RPS) or enhanced
communications in a local area network (LAN) or
wide-area network (WAN) environment. Refer to
Figure 22 for the correct switch settings.
The DX4020 has specific DIP switch settings for SDI
Address 80 when using the DX4020 for automation.
Refer to Figure 22 for the correct switch settings.
12.4.3 Supervision
Supervision of the DX4020 and DX402010I at SDI
Address 88 and 92 is available through programming
that ensures operation between the module and the
control panel.
If supervised and the module does not respond to
control panel supervision polls, SERVC SDI 88 or
SERVC SDI 92 appears at the keypad. The report to
the receiver includes the address of the troubled
module indicating which module needs service.
13.0 Programmer Connections
13.1 Programmer Connector
Control panel firmware version 8.11 and later does
not support the D5200 Programmer. Instead, a limited
local keypad programming mode is available. Refer to
Section 13.2 Installer Keypad and Local Programmers
Mode on page 50 for details.
Figure 23: Reset Pin
1 - Reset Pin locked (closed)
2 - Reset Pin normal (open) for normal control
panel operation
When the Reset Switch (labeled S1)
is closed, the communication module
at SDI Address 92 is disabled. While
in this mode, remote programming
communication over a network is only
supported by the communication
module at SDI Address 88. Remote
programming is always supported
over the phone line.
To Next Page
Loading...
