Bosch D7212GV3 - Page 5

D7212GV3 | Operation and Installation Guide | Figures
.
Bosch Security Systems, Inc. | 10/10 | F01U143079-03 5
Figures
Figure 1: System Configuration .................................8
Figure 2: Enclosure Mounting..................................14
Figure 3: Ground Fault Detect (S4) .........................15
Figure 4: Reset Pin ....................................................16
Figure 5: Service Walk Test Flow Chart.................19
Figure 6: Battery Terminals .....................................21
Figure 7: Charging and Battery LEDs.....................22
Figure 8: RJ31X Wiring............................................26
Figure 9: Phone Connector, Phone LED, and
Operation Monitor LED Locations.........26
Figure 10: On-board Point Sensor Loop Wiring......28
Figure 11: Rothenbuhler 5110/4001-42 High Security
Bell Wiring Configuration........................30
Figure 12: Wiring the Rothenbuhler 5110/4001-42
High Security Bell to the D7212GV3
Control Panel.............................................31
Figure 13: Connecting the D8125 POPEX to the
D7212GV3 Control Panel........................34
Figure 14: Program Record Sheet..............................37
Figure 15: D8128D OctoPOPIT Layout...................38
Figure 16: Connecting D8128D OctoPOPITs to the
D7212GV3.................................................40
Figure 17: Wiring Multiple D8128Ds Using Molex
®
Connectors.................................................41
Figure 18: D8128D OctoPOPIT Sensor Loops........42
Figure 19: D8129 Connections to the D7212GV3...43
Figure 20: Power at Keypads .....................................46
Figure 21: Keyswitch Wiring......................................47
Figure 22: DX4020 DIP Switch Settings ..................49
Figure 23: Reset Pin ....................................................49
Figure 24: D7212GV3 Faceplate ...............................51
Figure 25: D7212GV3, Power Supply Side System
Wiring .........................................................52
Figure 26: D7212GV3, Input Points and Peripheral
Devices System Wiring.............................53
Figure 27: D7212GV3, SDI Devices System Wiring
....................................................................54
Tables
Table 1: Related Documentation .............................6
Table 2: GV3 Series Control Panel Differences .....8
Table 3: Compatible Accessories ...........................10
Table 4: Compatible Keypads ................................12
Table 5: Ground Fault Impedance Specifications 15
Table 6: Battery Discharge and Recharge Schedule
....................................................................22
Table 7: Charging Status and Low Battery LEDs. 23
Table 8: Point Parameters.......................................28
Table 9: POPEX Modules.......................................32
Table 10: Extra Point Events ....................................32
Table 11: Off-Board Point Errors.............................33
Table 12: Data Expansion Loop Wire Specifications
....................................................................35
Table 13: D8128D OctoPOPIT Switch Settings..... 38
Table 14: Switch 5 Settings for Line Termination .. 39
Table 15: Terminal Strip Connections..................... 39
Table 16: D8129 OctoRelay Switch Settings .......... 43
Table 19: Keypad Address Settings........................45
Table 18: Keypad Connections ................................ 45
Table 19: SDI Device Connections.......................... 48
Table 20: Printer Address Switch Settings...............48
Table 21: Zonex 1, Points 9 to 40 ............................55
Table 22: Specifications.............................................56