Bosch D7412GV2 - TTP14: Point Trouble with D8125 INV and Inovonics Wireless Devices Connected to the Control Panel

D9412GV2/D7412GV2 | Troubleshooting Guide | 3.0 Troubleshooting
48 Bosch Security Systems, Inc. | 11/05 | F01U011024B
TTP14: Point Trouble with D8125INV and
Inovonics Wireless Devices
Connected to the Control Panel
A B C D
Procedure
Are all wireless points “missing”?
Are any wireless points “missing”?
If the D8125INV LCD display and keypad
backlight are both dark, refer to TTP51
Device or Module Does Not Have Power
on page 111.
On the D8125INV:
1. Enter the passcode, then press [ENT].
2. Enter the number of a wireless point that
is in trouble, then press [ENT].
3. View the transmitter’s mode (refer to Item
1 in Figure 26 on page 52), then refer to
Table 26 on page 51.
Is the mode correct for the desired
transmitter, or if using an FA210 or FA210W
Receiver, is the mode correct for the
desired operation?
Reprogram the transmitter as a new
transmitter.
Do not reconfigure the transmitter
as an existing transmitter.
You might need to perform this
procedure on more than one
transmitter.
During this service call, was the transmitter
programmed as an existing transmitter?
A B C D
On the D8125INV:
1. Enter the passcode, then press
[ENT].
2. Press [DIAG].
3. Press [1].
4. Enter the number of a wireless point
that is in trouble, then press [ENT].
5. Test the wireless transmitter.
6. Refer to Item 2 in Figure 27 on page
52, and refer to Table 27 on page
52.
Do the values match the conditions of
the wireless transmitter?
Move the transmitter to within 10 ft.
of the FA400 Receiver, then retest
the wireless transmitter.
• If the values still do not match
the conditions of the wireless
transmitter, remove the battery
from the old transmitter, and
install a new transmitter.
• If the values now match the
conditions of the wireless
transmitter, then either
relocate the transmitter,
relocate the receiver, or add
an FA570 Repeater to the
system.
After reconfiguring a wireless
system, always retest the
system to ensure all devices
operate correctly.
Using a keypad connected to the control
panel, view Point Assignments for the
point you are troubleshooting. Determine
which point index the point uses. View
that point index. Determine the Type and
Point Response (for more information,
refer to
Table 28 on page 52 and Table
29 on page 53).
Is the point programmed to respond as
desired?
Fix the programming problem.
View point status for the point you are
troubleshooting. Refer to
Table 28 on
page
52. Retest the wireless transmitter.
Does the point show the correct
condition of the wireless transmitter?
A B C E F