D9412GV4/D7412GV4 v2.03 | Installation and System Reference Guide | 18.0 Installer Menu
.
Bosch Security Systems, Inc. | 7/16 | F01U265457-09 136
B93x/B94x keypads Configuration of Keypad Programming
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to the [1] Program > [8] Disable Programming menu option. The keypad display shows
that programming is enabled.
3. Press the Edit softkey to disable keypad programming.
4. Press the No softkey.
5. Press the Save softkey to save the programming.
6. When the keypad shows Parameter Saved, escape from the menu.
18.2 [2] Wireless Menu
Use the Wireless menu to add, replace, remove, and diagnose points and repeaters.
18.2.1 [1] Points > [1] Enroll Point RFID Menu Parameters
In this menu, you can enroll RFID points.
Enroll Point RFID
B91x/B92x keypads Configuration of Point RFID enrollment
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to the [2] Wireless > [1] RF Points > [1] Enroll Point RFID menu option.
3. Press [PREV] or [NEXT] to scroll through the list, and go to the point for which you wish to
enroll a device, or simply enter the point number.
4. Press [ENTER] to add the device. The keypad instructs you to reset the device.
5. Initiate activity for the desired RADION device (walk through the coverage pattern if enrolling a
motion detector, or press the button on the keyfob if enrolling a keyfob, or open the door or
window if enrolling a door/window contact), or press the [RESET] button on an Inovonics
device.
6. When the keypad shows Point Enrolled, escape from the menu.
7. Verify the RFID shown on the keypad matches the RFID label on the activated device.
B93x/B94x keypads Configuration of Point RFID enrollment
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to the [2] Wireless > [1] RF Points > [1] Enroll Point RFID menu option.
3. Press [PREV]/ or [NEXT]/ to scroll through the list, and go to the point for which you wish
to enroll a device, or simply enter the point number.
4. Press the Yes softkey to add the device. The keypad instructs you to reset the device.
8. Initiate activity for the desired RADION device (walk through the coverage pattern if enrolling a
motion detector, or press the button on the keyfob if enrolling a keyfob, or open the door or
window if enrolling a door/window contact), or press the [RESET] button on an Inovonics
device.
5. Press the Save softkey.
6. When the keypad shows Point Enrolled, escape from the menu.
7. Verify the RFID shown on the keypad matches the RFID label on the activated device.
To Next Page
Loading...
