D9412GV4/D7412GV4 v2.03 | Installation and System Reference Guide | 18.0 Installer Menu
.
Bosch Security Systems, Inc. | 7/16 | F01U265457-09 140
4. Press [ENTER] to view the state. The menu scrolls through the following sub-categories, with
the results of the diagnostic check:
State
Tamper
Low-Battery
Maintenance
5. When you finish viewing the information, press [PREV] and [ESC] to exit the menu.
B93x/B94x keypads use of States (for RF points)
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to the [2] Wireless > [3] Diagnostics > [1] RF Points menu option. The keypad scrolls
through the list showing the option for state and the option for signal strength for the selected
point.
3. Press [PREV]/ or [NEXT]/ to scroll through the list, and go to the point for which you wish
to view diagnostic information.
4. Press the State softkey to view the state. The menu scrolls through the following sub-
categories, with the results of the diagnostic check:
State
Tamper
Low-Battery
Maintenance
5. When you finish viewing the information, press [PREV]/ and [ESC] to exit the menu.
Signal Strength (for RF points)
B91x/B92x keypads use of Signal Strength (for RF points)
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to the [2] Wireless > [3] Diagnostics > [1] RF Points > [1] Strength menu option.
3. Press [PREV] or [NEXT] to scroll through the list, and go to the point for which you wish to
view diagnostic information or enter the point number.
4. Press [ENTER] to view the state and then press [NEXT] to go to the signal strength option.
5. Press [ENTER] to view signal strength. The menu scrolls through the following sub-categories,
with the results of the diagnostic check:
Signal Strengths
Level
Margin
6. When you finish viewing the information, press [PREV] and [ESC] to exit the menu.
B93x/B94x keypads use of Signal Strengths (for RF points)
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to the [2] Wireless > [3] Diagnostics > [1] RF Points > [1] Strength menu option.
3. Press [PREV]/ or [NEXT]/ to scroll through the list, and go to the point for which you wish
to view diagnostic information, or enter the point number and press the Enter softkey.
4. Press [ENTER] to view the state and then press [NEXT]/ to go to the signal strength option.
5. Press the Signal softkey to view signal strength. The menu scrolls through the following sub-
categories, with the results of the diagnostic check:
To Next Page
Loading...
