D9412GV4/D7412GV4 v2.03 | Installation and System Reference Guide | 18.0 Installer Menu
.
Bosch Security Systems, Inc. | 7/16 | F01U265457-09 142
5. Press [ENTER] to view signal strength. The menu scrolls through the following sub-categories,
with the results of the diagnostic check:
Signal Strengths
Level
Margin
6. When you finish viewing the information, press [PREV] and [ESC] to exit the menu.
B93x/B94x keypads use of Signal Strengths (for RF repeaters)
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to the [2] Wireless > [3] Diagnostics > [2] RF Repeaters > [1] Strength menu option.
3. Press [PREV]/ or [NEXT]/ to scroll through the list, and go to the repeater for which you
wish to view diagnostic information, or enter the repeater number and press the Enter
softkey.
4. Press the Signal softkey to view signal strength. The menu scrolls through the following sub-
categories, with the results of the diagnostic check:
Signal Strengths
Level
Margin
5. When you finish viewing the information, escape from the menu.
18.3 [3] Diags Menu
Use the Diags menu to verify diagnostic information on the control panel.
18.3.1 [1] Wireless
The Wireless diagnostics are presented in two different menus for your convenience. Refer to [3] RF
Diagnostic Menu > [1] RF Points, page 131 and [3] RF Diagnostic Menu > RF Repeater Menu on page
132.
18.3.2 [2] Network Menu
Use the Network menu to view information about the control panel’s network connection.
Settings
B91x/B92x keypads use of Settings
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to the [3] Diags > [2] Network > [1] Bus Module (1) or [2]Bus Module (2) > [1]
Settings menu option. The keypad scrolls through the following sub-categories, indicating the
programming for:
Hostname
IPv4 Source IP
IPv6 Source IP (for B426 only)
Mac Address
3. When you finish viewing the information, escape from the menu.
To Next Page
Loading...
