Bosch D7412GV4 - Clear Event Memory

D9412GV4/D7412GV4/D7212GV4 Panel and Area Wide Parameters | en 111
Bosch Security Systems, Inc. Program Entry Guide F.01U.218.312 | 04 | 2012.03
L## Remote Program
Start a remote programming software (RPS) session when the phone rings at the control
panel.
L## Move to Area
Temporarily switch to a different area and perform keypad functions related to that area.
L## Display Rev
Display the control panel model name and software revision. For example:
– 9412GV4 REV ##.##
L## Service Walk
Start a Service Walk Test for all 24-hour Interior or Perimeter Controlled points in the control
panel.
Points are not included in this test if:
– Points are in an area that is already in a Walk Test Mode.
– Points are assigned to an area that is not enabled A# Area On.
– Points are in an area that is Master or Perimeter armed.
– Point source is Unassigned and the Point Index is set to 0.
When a Service Walk Test is initiated, one person can test all the points in the control panel
without assistance. The following features are provided with the Service Test Mode:
– Display indicates exactly how many points can be tested.
– Battery and bell tests do not occur during this Walk Test.
– The test ends when all points are tested or the test times out after 20 min of inactivity.
– Events print locally without alarm annunciation or reporting to the central station
receiver.
– D1255 Keypad displays a sequential count and the text for the point after each point is
activated and restored.
– The D1255 Keypad displays ALL PNTS TESTED.
– If enabled in Routing, Service Start and Service End are reported at the central station
receiver for the beginning and end of the test.
Default: Authority Levels 1-4, 15: Enabled (E)Authority Levels 5-14: Blank (-)
Selection: - or E
Function No. Function Name Alternate Keystroke
29 Remote Programming [COMMAND][4][3]
Default: Authority Levels 1-2, 15: Enabled (E)Authority Levels 3-14: Blank (-)
Selection: - or E
Function No. Function Name Alternate Keystroke
30 Move to Area [COMMAND][5][0]
Default: Authority Levels 1, 15: Enabled (E)Authority Levels 2-14: Blank (-)
Selection: - or E
Function No. Function Name Alternate Keystroke
32 Display Software
Revision
[COMMAND][5][9]
Default: Authority Levels 1, 15: Enabled (E)Authority Levels 2-14: Blank (-)
Selection: - or E
Function No. Function Name Alternate Keystroke
33 Service Walk test (Menu function only)