164 en | Schedules (Skeds) D9412GV4/D7412GV4/D7212GV4
F.01U.218.312 | 04 | 2012.03 Program Entry Guide Bosch Security Systems, Inc.
Enter the time of day when the window ends. This time marks the end of the period in which
users assigned to this window’s group can use their passcodes. The window stops at the end
of the minute. Make entries using a 24-hour clock (for example, 7:00 AM is entered as 07:00,
2:45 PM is entered as 14:45).
To disable the window, set the time to the default (00:00).
Do not program a single window to cross the midnight boundary. The window stop time must
be later than the window start time.
6.1.3 Holiday Indexes for User Group Windows
You can enable up to four Holiday Indexes to use with User Group Windows. Enable at least
one Holiday Index if UW# Xept Holiday is programmed as Yes for this user window, or if you
want this window to activate only on specific dates. Holidays are programmed in Holiday
Indexes. Refer to Section 6.3 Holiday Indexes, page 173 for programming information.
UW# Xept Holiday
Determine if the window is disabled on holidays, or is active only on holidays. Use the
instructions provided in the Section W# Xept Holiday, page 160W# Xept Holiday prompt 115.
UW# Holiday 1 [through 4]
Determine if the window is disabled on holidays, or is active only on holidays. Use the
instructions provided in Section W# Xept Holiday, page 160.
6.2 Schedules (Skeds)
Use the Skeds module to program the control panel to automatically execute functions that
are otherwise started by the end user at the keypad. Each sked can be programmed to occur
at a specific time on a specific date or day of the week. Up to 40 Skeds can be programmed.
A sked can be edited from the keypad if S## Time Edit? is Yes. The date and time can be
changed using the Change Sked function.
Each sked number can be programmed with one of 24 functions for the S## Function Code. In
addition to the function, a choice must be made as to what is affected by the function. For
example, when choosing Function 2 (Disarm Sked), the disarming is the function and the
selected areas are what is affected.
The functions and their associated parameters are listed in the Sked Function Code Table in
the D9412GV4/D7412GV4/D7212GV4 Program Record Sheet (P/N: F01U214958), and they are
explained in detail following the S## Function Code prompt 119.
Each sked can be programmed with up to four Holiday Indexes. The Holiday Indexes can
execute the sked on the holidays as well as on the date or day(s) of the week, or, they can
prevent the sked from executing on the holidays (refer to Section S## Xept Holiday, page 172).
NOTICE!
This prompt must be programmed if this User Group Window is assigned to a user group.
Default: No
Selection: Yes or No
Default: No
Selection: Yes or No
Yes The selected holiday index can be used by users in the User Group
window.
No The selected holiday index does not apply to users in this User Group.
To Next Page
Loading...
