Bosch D7412GV4 - Page 167

D9412GV4/D7412GV4/D7212GV4 Schedules (Skeds) | en 167
Bosch Security Systems, Inc. Program Entry Guide F.01U.218.312 | 04 | 2012.03
9 Test Report: This function emulates the Test
Report? sub-function of the Send Report?
keypad function ([COMMAND][4][1]). This
function generates a Test Report only from
Area 1 but contains panel-wide status
information. The report is sent to the
phone(s) programmed for Test and Status
Reports in Section 2.3.8 Communication
Attempts 20.
If Expand Test Report in Phone parameters is
programmed as Yes, the Test Report also
includes all off-normal states for events listed
in Test Reports (refer to
Section Table 3.9 Test Reports, page 36) and
some events listed in Diagnostic Reports
(refer to the footnotes with Table 3.10,
Page 37)
The Test Report can be deferred for up to 24
hours if any other report was sent since the
last Test Report. To defer the Test Report,
program S## Defer Test.
The Test Report can be sent every hour
beginning at the time scheduled in S## Time.
To send a Test Report every hour, program
S## Hourly Report.
Note:
To meet UL 864 requirements (D9412GV4 and
D7412GV4), use the Sked function to meet
the daily Test Report requirement.
S## Defer Test
Default: No
Selection: Yes or No
Enable sked to defer the
Test Report
S## Hourly Report
Default: No
Selection: Yes or No
Select Yes to send the Test
Report every hour.
Yes
No
Yes
No
Defer the Test
Report.
Send the Test
Report on
schedule.
Send the Test
Report every hour.
Send the Test
Report only as
scheduled.
10 Status Report: This function generates a
Status Report for each area that is enabled.
The report is sent to the phone(s)
programmed for Test and Status Reports in
Routing.
The Status Report can be deferred for up to
24 hours if any other report was sent since
the last Status Report. To defer the Status
Report, program S## Defer Status.
S## Defer Status
Default: No
Selection: Yes or No
Enable sked to defer the
Status Report.
Yes
No
Defer the Status
Report.
Send the Status
Report on
schedule.