188 en | SDI2 Modules D9412GV4/D7412GV4/D7212GV4
F.01U.218.312 | 04 | 2012.03 Program Entry Guide Bosch Security Systems, Inc.
3. Press [ENT] at the ADDRESS PARAM option to enter it.
4. Press [ENT] at the PORT NUMBER option. The currently configured port number shows.
5. Press [ENT] to change the port number. An editing cursor is enabled.
6. The [PREV] button acts as a [Backspace] key. Enter the desired port number using the
number buttons.
7. Press [ENT] to save the changes.
D1260
1. Refer to Section 2.5.1 Keypad Programming Menu, page 12 to access the Tools Menu and
navigate to the Programming option.
2. Press [ENTER] to enter the Programming option.
3. Press [ENTER] at the Address Parameters option to enter it.
4. Press [ENTER] at the Port Number option. The current configured port number shows.
5. Press the Edit softkey to change the port number. An editing cursor is enabled.
6. The Previous and Next softkeys move the cursor through the number. The Backspace
softkey allows you to erase characters. The Clear softkey allows you to clear the entered
numbers. Use the softkeys and the number buttons on the keypad to enter the new port
number.
7. Press the Save softkey to save the changes.
TCP Keepalive Time
IP Test Address
This is the test address that the network module will use when the IP Diagnostics tests are
activated from the keypad’s Tools Menu. The network address in this prompt is decoded and
an ICMP ping message is sent during the test so set this to an address that allows this form of
communication. You can enter an intranet address if you do not wish the system to test an
external IP address. Refer to Section 8.3.1 IP Diagnostics Keypad Menu (B420), page 189 for
further details.
Default: 45
Selection: 0 to 65 (in 1-sec increments)
NOTICE!
Domain Name characters are in accordance with RFC 1123 Requirements for Internet Hosts --
Application and Support.
Default: 8.8.8.8
Selection: Twenty alphanumeric characters
NOTICE!
For systems reporting over the internet, the test address can be set to a web server with fast
response time and high availability. This verifies that the Ethernet Communicator has at least
a limited internet connection outside the facility.
For all systems, including those that report only on private internal networks, the internet test
address can be pointed to a server or receiver in the central station. This will verify that the
Ethernet Communicator has at least a limited Ethernet connection to the specific site or
receiver to which reports will be sent. For example, receiver-01.your-company-domain.com.
To Next Page
Loading...
