D9412GV4/D7412GV4/D7212GV4 SDI2 Modules | en 191
Bosch Security Systems, Inc. Program Entry Guide F.01U.218.312 | 04 | 2012.03
Table 8.5 Wireless Repeater Capacities Per Control Panel
RPS supports the configuration of the enclosure tamper on each of the wireless repeater
modules. Refer to Section Enclosure Tamper, page 179.
RPS supports the configuration of the RFID for each of the wireless repeater modules.
RFID Wireless Repeaters
RFID (Radio Frequency device IDentification number). This is a unique number assigned to a
wireless device at the factory. It provides a unique way for the Wireless Receiver and Wireless
Repeaters to identify what device is transmitting. Since the Wireless Repeater is a receiver as
well as a transmitter it also is assigned an RFID so that the Wireless Receiver can determine
what Repeater is transmitting.
This RFID number is typically read off of the label that is affixed to the device. The label
location may differ for each RF device.
8.5.1 RF Repeaters Keypad Menu (RFID Wireless Repeaters)
Add Repeater
D1255
1. Refer to Section 2.5.1 Keypad Programming Menu, page 12 to access the TOOLS MENU
and navigate to the RF REPEATERS option.
2. Press [ENT] to enter the RF REPEATERS option.
3. Press [ENT] to enter the ADD REPEATERS option.
4. At the REPEATER 1-8 option, enter repeater number you wish to configure and press
[ENT] or scroll through the list of available repeater numbers by pressing [NEXT]. RFID:
NOT ASSIGNED shows.
5. Press [ENT]. The keypad indicates a transmission to the device.
6. Press the RESET button on the repeater to add it. The keypad reads REPEATER ADDED.
D1260
1. Refer to Section 2.5.1 Keypad Programming Menu, page 12 to access the Tools Menu and
navigate to the RF Repeaters option.
2. Press [ENT] to enter the RF Repeaters option.
3. Press [ENT] to enter the Add Repeaters option.
D9412GV4 D7412GV4 D7212GV4
888
NOTICE!
Even though the Wireless Receiver configuration is listed under the SDI2 Modules category
they are not physically connected to the SDI2 bus. They require that a B820 SDI2 Inovonics
Interface Module be configured as part of the system.
Default: 0
Selection: 0 - 99999999
NOTICE!
Attempting to enter a repeater with an assigned RFID generates an error tone.
NOTICE!
Attempting to enter a repeater with an assigned RFID generates an error tone.
To Next Page
Loading...
