Bosch D7412GV4 - Ribbon Bar Overview

36 en | Panel and Area Wide Parameters D9412GV4/D7412GV4/D7212GV4
F.01U.218.312 | 04 | 2012.03 Program Entry Guide Bosch Security Systems, Inc.
Table 3.9 Test Reports
Diagnostic Reports
Selecting Yes enables sending a report when the event occurs. If the off-normal state of the
events indicated by footnote 1 in Table 3.10, Page 37 still exists, the events report when a
Test Report is enabled and Expanded Test Report is programmed Yes. Refer to the Test
Reports sub-prompt in Section 3.3.9 Communication Attempts, page 30.
Report Selection Report Description
R# S: Alarm
1
Yes, No Status Alarm
R# S: Trouble
1
Yes, No Status Trouble
R# S: Supervised
2
Yes, No Status Supervised
R# Status Report Yes, No Status
R# S: Open
1
Yes, No Status Open
R# S: Close
1
Yes, No Status Close
R# Test Report Yes, No Test
R# S: Perimeter Inst
1
Yes, No Status Perimeter Instant Arm
R# S: Perimeter Delay
1
Yes, No Status Perimeter Delay Arm
R# S: Fire Supv
2
Yes, No Status Fire Supervision
R# S: Fire Alarm
3
Yes, No Status Fire Alarm Report
R# S: Fire Trbl
2
Yes, No Status Fire Trouble
R# S: Msng Fire
2
Yes, No Status Fire Missing
R# S: MsngBurgTr
2
Yes, No Status Burg Missing Trouble
R# S: MsngBurgAl
2
Yes, No Status Burg Missing Alarm
R# S: FireSpMsng
2
Yes, No Status Fire Supervision Missing
R# S: SuperMsng
2
Yes, No Status Non-fire Supervision Missing
R# S: DrLeftOpen
2
Yes, No Status Door Left Open
1
Information about this condition is sent with a Status Report.
2
Information about this condition is sent as S: Trouble Event with a Status Report.
3
Information about this condition is sent as S: Alarm Event with a Status Report.