Bosch D7412GV4 - B94 x;B93 x Settings Menu; Watch Mode

D9412GV4/D7412GV4/D7212GV4 Panel and Area Wide Parameters | en 99
Bosch Security Systems, Inc. Program Entry Guide F.01U.218.312 | 04 | 2012.03
User Command 7
Use this function to activate an alarm programmed in COMMAND 7 in the POINTS > Command
7 / Command 9 section.
User Command 9
Use this function to activate an alarm programmed in COMMAND 9 in the POINTS > Command
7 / Command 9 section.
Bypass a Point
Use this function to bypass individual points that have P## Bypassable enabled. Points within
the scope of the keypad can be bypassed where the function is entered (refer to
Section 3.11.1 Keypad (Command Center) Assignment, page 79.
The control panel ignores alarms and troubles, and does not display point faults when a point
is bypassed.
Unbypass a Point
Use this function to unbypass individual points that are programmed either P## Force Arm
Returnable or P## Bypass Returnable. Points within the scope of the keypad can be
unbypassed where the function is entered (refer to Section 3.11.1 Keypad (Command Center)
Assignment, page 79). The control panel responds to alarms and troubles, and displays point
faults when a point is unbypassed.
Reset Sensors
Use this function to activate the Reset Sensors function for Fire or Intrusion points
programmed as P## Resettable in Section 5.1 Point Index, page 130. Points within the scope
of the keypad where the function is entered reset. Refer to Section 3.11.1 Keypad (Command
Center) Assignment, page 79.
Default: P
Selection: -, E, or P
Function No. Function Name Alternate Keystroke
23 User COMMAND 7 [COMMAND][7]
Default: P
Selection: -, E, or P
Function No. Function Name Alternate Keystroke
24 User COMMAND 9 [COMMAND][9]
Default: P
Selection: -, E, or P
Function No. Function Name Alternate Keystroke
25 Bypass a Point [COMMAND][0]
Default: P
Selection: -, E, or P
Function No. Function Name Alternate Keystroke
26 Unbypass a Point [COMMAND][0][0]
Default: E
Selection: -, E, or P
Function No. Function Name Alternate Keystroke
27 Reset Sensors [COMMAND][4][7]