Commands
You can initiate functions with the
[CMD] key plus the
one or two digit command.
If you know the command number, press the [CMD] key
and then the one or two digit command.
Notice!
After you press
[CMD], you can use
/[PREV] or /
[NEXT] to move through the list of commands, and
press
[ENTER] when viewing the desired command.
Review the available commands in the following table.
48 en | B94x/B93x menu tree and commands Control Panels
2014.04 | 05 | F.01U.287.176 Bosch Security Systems, Inc.
To Next Page
Loading...
