All On
Turning an area All On turns on all points in the area and
provides entry and exit delay. For example, you can turn
on the area and leave through a door (within exit delay
time) without creating an alarm event. When you turn
the area All On, the display shows how many seconds of
exit delay time remain to exit the protected area. Leave
before the exit delay time expires.
Leaving after
exit delay expires causes entry delay to
start. It may also cause an alarm on an interior device.
Enter your passcode to turn off the system.
Turning areas All On:
1. Open the Main menu.
2. Press [On/Off] to open the menu.
3. Press [All On] to open the menu.
4. Press [All On Delay] to open the menu.
5. Enter your passcode and press [ENTER]. The keypad
shows Exit Now! and sounds during the exit delay.
6. Exit the area or enter your passcode again to stop
the system from turning on. If you turn your system
All On and don't exit, the system automatically
switches to Part On.
14.1.1
Control Panels B94x/B93x On/Off menu | en 51
Bosch Security Systems, Inc. 2014.04 | 05 | F.01U.287.176
To Next Page
Loading...
