Bosch D9412G - Control Panel Faceplates; D9412 G Faceplate Diagram

D9412G/D7412G | Program Entry Guide | 2.0 9000MAIN EN | 63
Bosch Security Systems | 10/03 | 47775E
L## Chg Display
Default: See Program Record Sheet
Selection: Blank or E
#15 Change Display [COMMAND][4][9]
Change the display (bright display, dim display, and
time display) in the area where this command center
is assigned.
L## Chg Time/Date
Default: See Program Record Sheet
Selection: Blank or E
#16 Change Time and Date [COMMAND][4][5]
Change the date and time for the control panel in
this area.
L## Chg Passcode
Default: See Program Record Sheet
Selection: Blank or E
#17 Change Passcodes [COMMAND][5][5]
Change a user passcode.
L## Add User
Default: See Program Record Sheet
Selection: Blank or E
#18 Add User [COMMAND][5][6]
Add/change users, add/change authority levels,
add/change tokens/cards.
9210 NOT READY appears if a door
controller is not assigned (see CC#
Assign Door in Section 2.10.1 Cmd Cntr
(Command Center) Assignment) to the
command center used to add/change
tokens/cards.
L## Del User
Default: See Program Record Sheet
Selection: Blank or E
#19 Delete User [COMMAND][5][3]
Delete users.
0101
0101
0101
Although an individual user (001 through
249) can be deleted separately, take
caution. User passcode, token/cards
cannot be deleted individually within a
group (for example, User 001 has three
additional sub-users that use the same
authority levels for that group). When
dealing with an individual user, change
that user’s token/passcode so other
users in the group do not need to be re-
added.
L## Extend Close
Default: See Program Record Sheet
Selection: Blank or E
#20 Extend Close [COMMAND][5][1]
Change the closing time in the area where the
function is entered.
L## View Log
Default: See Program Record Sheet
Selection: Blank or E
#21 View Log (MENU FUNCTION only)
View all panel-wide events in the control panel’s
memory log.
L## Print Log
Default: See Program Record Sheet
Selection: Blank or E
#22 Print Event Log (MENU FUNCTION only)
Print all panel-wide events from the log to the
printer in the area where the user is executing this
function.
This item can also be accessed using the
Service Menu ([9][9][ENT]).
L## User Cmd 7
Default: See Program Record Sheet
Selection: Blank or E
#23 User COMMAND 7 [COMMAND][7]
Can be used in Function Menu. Generate the alarm
programmed at COMMAND 7 in the RADXPNTS
Handler.