D9412GV3/D7412GV3/D7212GV3 Setting DIP Switches | en 19
Bosch Security Systems, Inc. Quick Reference Guide F01U170805 | 01 | 2010.11
9 Setting DIP Switches
9.1 D9127 U/T POPIT Dip Switch Key
POPIT addresses are binary. Refer to Table 9.1:
Table 9.1 POPIT Dip Switch Keys
To calculate the switch settings for POPITS, you must determine the value to use in the
calculation. For addresses 9 through 127, subtract 9. For addresses 129 through 247,
subtract 129. Use the following procedure with address 48 as the example, substituting the
actual values in your calculation.
1. Subtract 9 from 48. The result is 39.
2. Set the switches that add up to 39 to the OFF positions (32 + 4 + 2 + 1 = 39).
SW 1 OFF = 32
SW 4 OFF = 4
SW 5 OFF = 2
SW 6 OFF = 1
9.2 D9210B Switch Settings
For additional information, refer to the Access Control Interface Module D9210B Operation and
Installation Guide (P/N: 32206).
9.3 D720, D1255, D1260 Dip Switch Settings
For additional information, refer to:
– D720 Series Keypads Installation Instructions (P/N: 7406918000)
– D1255/D1255B Keypads Installation Instructions (P/N: 7406819000)
– D1260/D1260B Keypads Installation Guide (P/N: 48101)
9.4 D9131A Dip Switch Settings
For additional information, refer to the Parallel Printer Interface D9131A Installation Guide
(P/N: F01U135506).
9.5 D8129 OctoRelay Dip Switch Settings
For additional information, refer to the D8129 OctoRelay Module Operating and Installation
Guide (P/N: F01U036302).
9.6 D8128C OctoPOPIT Dip Switch Settings
For additional information, refer to the D8128C OctoPOPOIT Module Operating Instructions
(P/N: 7407710000).
9.7 D8128D OctoPOPIT Dip Switch Settings
For additional information, refer to the D8128D OctoPOPOIT Module Installation Guide
(P/N: F01U070537).
Switch Number 0123456
Binary Value 6432168421
To Next Page
Loading...
