Bosch D9412GV4 - Entry delay tone and display; Exit delay tone and display; Keypress tones

Bosch Security Systems, Inc. | 3/12 | F01U266054-01 6
13.5.1 Address and Emulation Settings
13.5.2 Supervision
13.5.2 Local RPS Programming
13.5.3 Ethernet Communications Module Faults
13.6 B820 SDI2 Inovonics Interface Module
13.7.1 Supervision
13.7.2 Wireless Receiver Faults
13.7.3 Wireless Repeaters Faults
14.0 Installer Keypad Tools ....................................... 73
14.1 RPS Access Reports
15.0 Accessory Connector ......................................... 74
16.0 Faceplates ............................................................ 75
16.1 GV4 Series Faceplate
Appendix A: System Wiring Diagrams ..................... 76
A.1 Power Supply Side System Wiring
A.2 Input Points and Peripheral Devices
Wiring Diagrams
A.3 SDI and Zonex Devices System Wiring
System Wiring
Appendix B: Point Address Charts .......................... 81
B.1 Zonex 1 Points
B.2 Zonex 2 Points
B.3 SDI2 Points
Appendix C: Specifications ........................................ 84
C.1 Control Panel Power Supply
C.2 Terminal Wiring
Figures
Figure 1: System Configuration
Figure 2: Enclosure Mounting
Figure 3: Enabling Ground Fault Detection
Figure 4: Reset Pin
Figure 5: Service Walk Test Flow Chart Example
Figure 6: Battery Terminals
Figure 7: Non-Power-Limited Wiring
Figure 8: Charging and Battery LEDs
Figure 9: RJ31X Wiring
Figure 10: Phone Connector, Phone LED, and
Operation Monitor LED Locations
Figure 11: D928 Dual Phone Line Switcher
Figure 12: On-board Point Sensor Loop Wiring
Figure 13: Wiring the Rothenbuhler 5110/4001-
42 High Security Bell to the Control
Panel
Figure 14: Connecting the D8125 POPEX to the
D9412GV4 Control Panel
Figure 15: Connecting the D8125 POPEX to the
D7412GV4 and D7212GV4 Control
Panels
Figure 16: D8128D OctoPOPIT Layout
Figure 17: Connecting D8128D OctoPOPITs to
the D9412GV4
Figure 18: Connecting D8128D OctoPOPITs to
the D7412GV4 or D7212GV4
Figure 19: Wiring Multiple D8128Ds Using
Interconnect Wiring
Figure 20: D8128D OctoPOPIT Sensor Loops
Figure 21: D8129 Connections to the D9412GV4
Figure 22: D8129 Connections to the D7412GV4
or D7212GV4
Figure 23: D811 Arm Status Relay Module Wiring
to the D9412GV4
Figure 24: D811 Arm Status Relay Module Wiring
to the D7412GV4 or D7212GV4
Figure 25: External Power to SDI Devices
Figure 26: Keyswitch Wiring
Figure 27: DX4020 DIP Switch Settings
Figure 28: B208 Switches Set to Address 9
Figure 29: B308 Switches Set to Address 9
Figure 30: B420 Switch Set to Address 1
Figure 31: B820 Switch Set to Address 1
Figure 32: Accessory Connection on D9412GV4
and D7412GV4
Figure 33: D9412GV4/D7412GV4/D7212GV4
Faceplate
Figure 34: D9412GV4/D7412GV4/D7212GV4 Power
Supply Side System Wiring (Power and
Phone)
Figure 35: D9412GV4/D7412GV4/D7212GV4 Input
Points and Peripheral Devices System
Wiring
Figure 36: D9412GV4 SDI and Zonex Devices
System Wiring System Wiring
Figure 37: D7412GV4/D7212GV4 SDI and Zonex
Devices System Wiring
Figure 38: D9412GV4/D7412GV4/D7212GV4 SDI2
Devices System Wiring