INSTALLING ACCESSORIES
Clean the insert shank end of the accessory to
remove any debris, then lightly grease with a
light oil or lubricant.
Pull and hold locking sleeve backward. Insert
accessory into the tool holder through the dust
shield, while twisting and pushing inward until
it sets into place. Release locking sleeve to
lock bit in place. Pull outward on the
accessory to be certain it is locked into the
tool holder (Fig. 2).
NOTE: The high efficiency available from the
hammers can only be obtained if sharp and
undamaged accessories are used. The "cost"
to maintain sharp and undamaged
accessories is more than offset by the "time
saved" in operating the tool with sharp
accessories.
REMOVING ACCESSORIES
Accessories may be hot
after use. Avoid contact
with skin and use proper protective gloves or
cloth to remove.
To remove an accessory, pull and hold locking
sleeve backward and then pull bit forward. All
accessories should be wiped clean after
removing (Fig. 3).
-8-
Assembly
LOCKING SLEEVE
DUST SHIELD
AUXILIARY HANDLE
The tool must be supported with the auxiliary
handle, which can be swiveled 360˚. To
reposition and/or swivel the handle, loosen the
hand grip, move the handle to the desired
position along the barrel and securely retighten
the hand grip (Fig. 1).
FIG. 2
FIG. 3
To Next Page
Loading...
