14
Installation inside the wall cupboard
8. Cut the wall masking strip down to size if
necessary and screw it onto the wall
cupboard.
2. Align handle and attach it to the
extractor with the 3 enclosed screws.
Attaching a handle to the vapour
extractor:
❑
A handle can be attached to the vapour
extractor.
❑
This handle can either be a wooden
strip that matches the kitchen
cupboards or a the handle that is
available as an optional accessory (see
section on optional accessories in the
user instructions).
1. Use the enclosed template
O
III to mark
the 3 mounting points on the handle
and start the hole with a gimlet.
Details for drilling:
l 2 mm – max. 10 mm deep.
To Next Page
Loading...
