– Green: Each Serial ATA drive carrier has a green LED. When illuminated, this green LED
(on the front of the SATA drive carrier) indicates drive activity. A connection to the SATA
backplane enables this LED to blink on and off when that particular drive is being
accessed.
– Red: The red LED indicates a SAS/SATA drive failure. If one of the SAS/SATA drives fail,
you should be notified by your system management software.
DIVAR IP 7000 2U System overview | en 13
Bosch Sicherheitssysteme GmbH Installation Manual 2014.12 | V4 | DOC
To Next Page
Loading...
