Installing hard drives
This chapter describes the removing and installing of hard drives.
Removing hard drive trays
The drives are mounted in drive carriers to simplify their installation and removal from the
chassis. These carriers also help promote proper airflow for the drive bays.
1 Drive carrier
2 Dummy drive
To remove hard drive trays from the chassis:
1. Press the release button on the drive carrier. This extends the drive carrier handle.
2. Use the handle to pull the drive out of the chassis.
Notice!
Except for short periods of time (swapping hard drives), do not operate the unit with the
hard drives removed from the bays.
3.2
3.2.1
DIVAR IP 7000 2U Chassis setup and maintenance | en 15
Bosch Sicherheitssysteme GmbH Installation Manual 2014.12 | V4 | DOC
To Next Page
Loading...
