Bosch DIVAR IP 7000 2U - Page 37

Basically, the RAID controller writes the raidconfiguration - information (COD = configuration-
on-disk) in an only field on each disk managed by the controller. The data area of a disk is
never used by this, no matter, how often you write and delete the RAID configuration. "New"
or "Clear" Configuration deletes the COD, if available.
"Save Configuration" saves the new COD. "Initialize" deletes the Disk Data (OS).
DIVAR IP 7000 2U Recovering the unit | en 37
Bosch Sicherheitssysteme GmbH Installation Manual 2014.12 | V4 | DOC