How to use the Event Viewer in the Controller Bios Utility
Click on an event in the main screen; choose "physical" or "virtual drive" and an event class
(informational, warning, critical or fatal); start at an appropriate sequence number (minus a
few hundred), choose the number of events.
In this example, we choose a start sequence 5800 (from 6412) and all 612 events left. We find
a timestamp, that PD (Physical Drive) 6 was removed. PD 4 stops rebuilding.
Finally, PD 4 is also removed.
DIVAR IP 7000 2U Recovering the unit | en 39
Bosch Sicherheitssysteme GmbH Installation Manual 2014.12 | V4 | DOC
To Next Page
Loading...
