Bosch DS7400Xi - Timer, Report, and Communication Settings

DS7400Xi ( 4+) Reference Guide Copyright © 2007 Bosch Security Systems, Inc. P/N: F01U035325-01 Page 49
10.17 Open/Close Report Control Programming: Program Address (3149)
See Glossary (section 6.12) for further details.
4Select Options 0 1 2 3 5 6 7 8 9
Do not report opens or closes
Report opens and closes in Partition 1
Report opens and closes in Partition 2
Report opens and closes in Partition 3
Report first Partition to open and last Partition to close**
Report opens and closes in Partition 4
Enter the Data Digit as a:
Send Closing and
Bypass reports after
Send Closing and
Bypass reports at close
1
0
Report opens and closes in Partition 5
Report opens and closes in Partition 6
Report opens and closes in Partition 7
Report opens and closes in Partition 8
exit delay
Data Dig
it
12
** = When using this option, all partitions should have the same account code.
Data Dig
it
12
0
10.18 Open/Close & Zone Report Control Programming: Program Address (3151)
This section allows you to decide which phone number will send open and close reports, zone alarm, zone restoral, and zone trouble
reports.
10.19 Report Control Programming: Program Address (3152)
This section allows you to decide which phone number will send reports other than open/close reports and zone reports.
NOTE: Data Digit 1 does
not include Open
and Close
Reports or Zone
Reports (see
sections 10.17
and 10.18).
Select Option DD
0
1
2
3
Alternate between both Phone Numbers
Report to Phone Number 1
Report to Phone Number 2
Report to Phone Number 1 and 2
Data Digit 2
must be 0
Data Digit
1
2
0