Page 62 P/N: F01U035325-01 Copyright © 2007 Bosch Security Systems, Inc. DS7400Xi (4+) Reference Guide
10.36 Octal Relay Module Output Programming (continued)
10.36.3 Follow Function: Program Addresses (2740-2771)
To program an Octal Relay Module for Follow Output Function, follow the steps below.
1. Select Octal Relay to program.
2. Program Data Digit 1 of Program Address A as 3 for Follow Function.
3. Program Data Digit 2 of Program Address A for the desired function.
4. Program Data Digit 1 and 2 of Program Address B for the desired function.
Once both Address A and Address B have been programmed, proceed to program the next Octal Relay.
For Octal Relay Partition Assignment, see section 10.36.5.
To Next Page
Loading...
