Bosch DWF97RV20 - Page 8

en Basic operation
8
3.
Release to save the setting.
7.13 Switching on the lighting
The lighting can be switched on and off independently
of the ventilation system.
Note:Colour temperature settings are available in the
HomeConnect app provided the appliance has this
function.
▶
Press ⁠.
7.14 Setting the brightness
▶
Press and hold until the required brightness is
reached.
7.15 Switching on Ambient Light
1
You can switch on the Ambient Light independently of
the ventilation system.
▶
Press ⁠.
7.16 Ambient Light
1
- Setting the brightness
▶
Press and hold until the required brightness is
reached.
7.17 Ambient Light
1
- adjusting the colour
Requirement:The appliance is switched off.
1.
Press ⁠.
2.
Use the control ring to select the colour you want.
7.18 Setting the intermediate position for
the filter cover
On some appliances, the filter cover can be adjusted to
an intermediate position. The intermediate position can
be used to eliminate particularly strong cooking smells
and large amounts of steam.
▶
Take hold of the filter cover in the centre and open it
carefully.
7.19 Saturation indicator
If the grease filters or odour filters are saturated, cor-
responding symbols flash after the appliance is
switched off.
Note:You can set the saturation indicator in the Home
Connect app depending on the filter used.
Clean the saturated grease filters and, in doing so, ob-
serve the cleaning instructions in these instructions.
Change the saturated odour filters and observe the in-
structions in the accompanying instructions.
If odour filters can be regenerated, follow the instruc-
tions in the accompanying instructions.
7.20 Resetting the saturation indicator
After cleaning the grease filter or after changing the
odour filter, the saturation indicator can be reset.
Resetting the saturation indicator, variant 1
After cleaning the grease filter or after changing the
odour filter, the saturation indicator can be reset.
Requirements
¡ After the appliance has been switched off, ap-
pears in the display for the grease filter.
¡ After the appliance has been switched off, ap-
pears in the display for the odour filter.
▶
Press ⁠.
a The saturation indicator is reset.
Resetting the saturation indicator, variant 2
After cleaning the grease filter or after changing the
odour filter, the saturation indicator can be reset.
Requirements
¡ After the appliance has been switched off, ap-
pears in the display for the grease filter.
¡ After the appliance has been switched off, ap-
pears in the display for the odour filter.
1.
To reset the saturation indicator for the grease filter,
press ⁠.
2.
To reset the saturation indicator for the odour filter,
press ⁠.
a The saturation indicator is reset.
7.21 Setting the saturation indicator
The saturation indicator must be adjusted depending
on the filter used.
Requirement:The appliance is switched off.
1.
Press and hold ⁠.
‒ To set circulating-air mode (non-regenerable fil-
ter), use the control ring to change the display to
⁠.
‒ To set circulating-air mode (regenerable filter),
use the control ring to change the display to ⁠.
‒ To set air extraction mode, use the control ring to
change the display to ⁠.
2.
Release to save the setting.
1
Depending on the appliance specifications