36 en | Product Description Modular Fire Panel
F.01U.028.089 | 5.4 | 2009.08 Product Information Bosch Sicherheitssysteme GmbH
1.15.1 ANI 0016 A Annunciator Module
The annunciator module has 16 red and 16 yellow LEDs for displaying the operating states of
16 definable detector points.
The activation of each LED is specified using the FSP-5000-RPS Programming Software.
This defines which detection points will activate the LEDs in which state.
Technical specifications
1.15.2 BCM-0000-B Battery Controller Module
The module monitors the power supply for the complete panel and regulates battery charging
as a function of time and temperature. The button has three functions, which are dependent
on the status of the battery controller module:
– The four LEDs on the module light up as a confirmation and LED test each time the
button is pressed.
– If the batteries have a voltage of between 18 V and 21 V, the battery charging procedure
can be started manually. Please note that a power supply must be available.
– The 24 V switch outputs can be reset. The switch output is deactivated if a fault occurs.
Display elements 16 red LEDs, 16 yellow LEDs
Input voltage 20 V DC to 30 V DC / 5 V DC ± 5%
Maximum current consumption
- Standby mode (all LEDs off)
- In the event of an alarm (all
LEDs on)
6mA
26 mA
Dimensions (H x W x D) Approx. 127 x 96 x 60 mm (5.0 x 3.8 x 2.4 inches)
Weight Approx. 206 g (approx. 7.3 ounces)
24 V
To Next Page
Loading...
