English - 3
■
Switch off the power tool as soon as the
tool insert jams. Be prepared for a high re-
action torque, which will cause a kickback.
The tool insert jams when:
– the power tool is overloaded or
– it becomes wedged in the workpiece.
■
Hold the power tool only by the insulated
gripping surfaces when performing an op-
eration where the cutting tool may contact
hidden wiring or its own power cord.
Con-
tact with a “live” wire will also make exposed
metal parts of the power tool “live” and shock
the operator.
The numbering of the product features refers to
the representation of the tool on the graphics
page.
While reading the operating instructions, unfold
the graphics page of the tool and leave it open.
1
Keyless chuck*
2
Flat of nut
3
Lock-on button for On/Off switch
4
Speed preselection thumbwheel
5
On/Off switch
6
Rotational direction switch
7
Gear selector
8
Wing bolt for depth stop adjustment
9
Wing bolt for auxiliary handle adjustment
10 Depth stop
11 Auxiliary handle
12 Chuck key*
13 Key chuck*
14 Drive bit*
15 Drill spindle with hexagon socket
16 Locking screw
* Not all of the illustrated or described accessories are
included as standard delivery.
Measured values determined according to
EN 60 745.
The A-weighted sound pressure level of the
tool is typically 80 dB (A). Measuring inaccuracy
K = 3 dB.
The noise level when working can exceed
85 dB (A).
Wear hearing protection!
The weighted acceleration is typically 3.0 m/s
2
.
The vibration emission level given
in this information sheet has been
measured in accordance with a standardized test
given in EN 60 745 and may be used to compare
one tool with another.
The vibration emission level will vary because of
the ways in which a power tool can be used and
may increase above the level given in this infor-
Product Features
Tool Specifications
Drill GBM 13-2 RE
PROFESSIONAL
Article number 0 601 169 5..
Rated power input [W] 550
Output power [W] 285
No-load speed
1st gear [rpm] 0–1 000
2nd gear [rpm] 0–1 900
Rated speed
1st gear [rpm] 0 – 550
2nd gear [rpm] 0–1 000
Rated torque
(1st/2nd gear)
[Nm] 11.5/6.0
Infinitely variable
speed control
●
Right/left rotation ●
Chuck clamping
range, max.
[mm] 1–13
Max. drilling Ø
(1st/2nd gear)
Steel [mm] 13/8
Wood [mm] 32/20
Aluminum [mm] 20/12
Weight according
to EPTA-Proce-
dure 01/2003
[kg] 1.9
Safety class / II
Please observe the article number on the type plate of your
machine. The trade names of the individual machines may
vary.
The values given are valid for nominal voltages [U] of
230/240 V. However, these values can vary for lower volt-
ages and models made for specific countries.
Noise/Vibration Information
2 609 932 509.book Seite 3 Dienstag, 29. November 2005 11:31 11
8 • 2 609 932 509 • TMS • 24.11.05
To Next Page
Loading...
