English - 1
The numbering of the machine elements refers to
the illustration of the machine on the graphics
page.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
1 Dust bag
2 Lock-on button for On/Off switch
3 Outlet piece
4 On/Off switch
5 Belt speed thumbwheel (GBS 100 AE)
6 Auxiliary handle
7 Clamping lever
8 Adjustment knob for belt position
9 Protective cap
10 Dust passage
11 Guide plate*
12 Graphite plate*
* Not all of the accessories illustrated or described are
included as standard delivery.
The machine is intended for dry sanding of wood,
plastic, metal, filler and coated surfaces – at high
removal rates.
Measured values determined according to
EN 60 745.
Typically the A-weighted sound pressure level of
the machine is 80 dB (A). Measurement uncer-
tainty K=3 dB.
When working, the noise level can exceed
85 dB (A).
Wear hearing protection!
The typical hand/arm vibration is below 2.5 m/s
2
.
The vibration emission level
given in this information sheet
has been measured in accordance with a stand-
ardised test given in EN 60 745 and may be used
to compare one tool with another.
The vibration emission level will vary because of
the ways in which a power tool can be used and
may increase above the level given in this infor-
mation sheet. This could lead to a significant un-
derestimate of exposure when the tool is used
regularly in such a way.
NOTE: To be accurate, an estimation of the level
of exposure to vibration experienced during a
given period of work should also take into ac-
count the times when the tool is switched off and
when it is running but not actually doing the job.
This may significantly reduce the exposure level
over the total working period.
Tool Specifications
Belt sander GBS 100 A
PROFESSIONAL
GBS 100 AE
PROFESSIONAL
Article number 0 601 276 9.. 0 601 276 7..
Rated power input [W] 1 200 1 200
Output power [W] 550 550
No-load belt speed [m/min] 450 250 – 450
Length of sander belt [mm] 620/610 620/610
Width of sander belt [mm] 100 100
Belt speed preselection – ●
Connection for self/external dust collection ● ●
Weight according to
EPTA-Procedure 01/2003
[kg] 6.3 6.3
Protection class / II / II
Please observe the article number on the type plate of your machine. The trade names of the individual machines may vary.
The values given are valid for nominal voltages [U] of 230/240 V. For lower voltages and models for specific countries,
these values can vary.
Machine Elements
Intended Use
Noise/Vibration Information
To Next Page
Loading...
