Bosch GDS18V-740 - Assembly Instructions; Battery Pack Installation and Removal Steps; Accessory Insertion and Removal Guide

11
Inserting and Releasing
Battery Pack
Set Forward/Reversing lever 3 to the center
(locked position). Slide charged battery pack 5
into the housing until the battery pack locks
into position (Fig. 2).
Your tool is equipped with a secondary locking
latch to prevent the battery pack from
completely falling out of the handle, should it
become loose due to vibration.
To remove the battery pack, press the battery
pack release button 6 and slide the battery
pack 5 completely out of tool housing (Fig. 3).
Inserting and Removing
Accessories
Attach only high quality impact ready
accessories with the proper size square drive
designed for use with impact wrenches. To
install a socket 10, simply push completely
onto output drive 1 (Fig. 4, 5).
Through hole 2 allows for more secure socket
retention via compatible socket and use of
accessory pin and ring or one-piece retainer.
Follow accessory retention device
manufacturer's recommendations for use of
through hole.
Assembly
6
5
5
Fig. 2 Fig. 3
(1
0)
(1)
(2)
Fi
g
.
5
GDS18V-770
(10)
(1
)
F
ig.
4
GDS18V-740
Disconnect battery pack from tool before making any assembly,
adjustments or changing accessories. Such preventive safety measures
reduce the risk of starting the tool accidentally.