16 | English
1 609 92A 14V | (10.2.15) Bosch Power Tools
The severed plug must be disposed of to avoid a possible
shock hazard and should never be inserted into a mains sock-
et elsewhere.
Products sold in AUS and NZ only: Use a residual current de-
vice (RCD) with a rated residual current of 30 mA or less.
Product Description and Specifica-
tions
Read all safety warnings and all instruc-
tions. Failure to follow the warnings and in-
structions may result in electric shock, fire
and/or serious injury.
While reading the operating instructions, unfold the graphics
page for the machine and leave it open.
Intended Use
The machine is intended for lengthways and crossways cut-
ting of wood with straight cutting lines as well as mitre cuts in
wood while resting firmly on the workpiece. With suitable saw
blades, thin-walled non-ferrous metals, e. g., profiles, can al-
so be sawed.
Working ferrous metals is not permitted.
Product Features
The numbering of the product features refers to the illustra-
tion of the machine on the graphics page.
1 Blade guard
2 Lock-off button for On/Off switch
3 On/Off switch
4 Auxiliary handle (insulated gripping surface)
5 Spindle lock button
6 Scale for mitre angle
7 Wing bolt for parallel guide
8 Wing bolt for bevel-angle preselection
9 Cutting mark, 0°
10 Cutting mark, 45°
11 Parallel guide*
12 Retracting blade guard
13 Riving knife (GKS 85 G)
14 Base plate
15 Lever for retracting blade guard
16 Wing bolt for bevel-angle preselection
17 Chip ejector
18 Handle (insulated gripping surface)
19 Hex key
20 Clamping bolt with washer
21 Clamping flange
22 Saw blade*
23 Mounting flange
24 Saw spindle
25 Screw for attachment of riving knife (GKS 85 G)
26 Extraction adapter*
27 Fastening screw for extraction adapter (GKS 85)*
28 Clamping lever for cutting-depth preselection
29 Cutting-depth scale
30 Set of screw clamps*
31 Guide rail*
32 Connection piece*
33 Vacuum hose*
*Accessories shown or described are not part of the standard de-
livery scope of the product. A complete overview of accessories
can be found in our accessories program.
Technical Data
Circular Saw GKS 85 GKS 85 G
Article number
3 601 E7A 0.. 3 601 E7A 9..
Rated power input
W22002200
No-load speed
min
-1
5000 5000
Rotational speed under load, max.
min
-1
3500 3500
Cutting depth, max.
–for 0° bevel angle
–for 45° bevel angle
mm
mm
85
65
85
65
Spindle lock
Constant electronic control
–
Reduced starting current
Base plate dimensions
mm 383 x 170 406 x 208
Saw blade diameter, max.
mm 235 235
Saw blade diameter, min.
mm 230 230
Blade thickness, max.
mm 2.2 2.2
Tooth thickness/setting, max.
mm 3.2 3.2
The values given are valid for a nominal voltage [U] of 230 V. For different voltages and models for specific countries, these values can vary.
OBJ_BUCH-293-007.book Page 16 Tuesday, February 10, 2015 8:40 AM
To Next Page
Loading...
