page heading
SAVE THESE INSTRUCTIONS 5
The definitions below describe the level of severity for each signal word.
Please read the manual and pay attention to these symbols.
This is the safety alert symbol. It is used to alert you to potential
personal injury hazards. Obey all safety messages that follow this
symbol to avoid possible injury or death.
DANGER indicates a hazardous situation which, if not avoided, will
result in death or serious injury.
WARNING indicates a hazardous situation which, if not avoided, could
result in death or serious injury.
CAUTION indicates a hazardous situation which, if not avoided, could
result in minor or moderate injury.
Safety Symbols
Read all instructions. Failure to follow all instructions listed below may result
in hazardous radiation exposure, electric shock, fire and/or serious injury.
The term “laser tool” in the warnings listed below refers to your battery-operated (cordless) laser tool.
SAVE ALL WARNINGS AND INSTRUCTIONS
FOR FUTURE REFERENCE
The following label is on your tool for your safety. ALWAYS BE AWARE of its location when using
the laser.
DO NOT direct the laser beam at
persons or animals and do not
stare into the laser beam yourself.
This laser tool produces class 2 la-
ser radiation and complies with 21
CFR 1040.10 and 1040.11 except for confor-
mance with IEC 60825-1 Ed. 3., as described in
Laser Notice No. 56, dated May 8, 2019.” This
can lead to persons being blinded.
DO NOT stare directly at the laser beam or
project the laser beam directly into the eyes of
others. Serious eye injury could result.
DO NOT place the laser tool in a position that
may cause anyone to stare into the laser beam
intentionally or unintentionally. Serious eye in-
jury could result.
ALWAYS make sure that any bystanders in the
vicinity of use are made aware of the dangers
of looking directly into the laser tool.
Never aim the beam at a workpiece with a re-
flective surface. Bright shiny reflective sheet
steel or similar reflective surfaces are not rec-
ommended for laser use. Reflective surfaces
could direct the beam back towards the operator.
General Safety Rules
GLL50-20 GLL50-20G
160992A8JG GLL50-20 G 202306.indd 5 6/9/23 9:46 AM
To Next Page
Loading...
