Bosch GLM 100-25 C - Optimisation of Laser Point Visibility; Measuring Process

12 | English
Camera
Press the button to switch the camera on or off.
The selected setting remains saved after you switch off the measuring tool.
For larger distances (approx.>5m), a target marking is additionally shown for marking
the measuring point.
Optimisation of the Visibility of the Laser Point
Especially when using the measuring tool outdoors in direct sunlight, but also for long
stretches indoors, it may be that the laser point is not visible. Switch the camera on. The
visibility of the laser point/measurement target can additionally be improved by:
– Setting the display brightness(see "Setting Display Brightness ", page20)
– Use of zoom with the button
Measuring Process
Once switched on, the measuring tool is in the length measurement function.
Once the measuring tool has been switched on, the rear edge of the measuring tool is se-
lected as the reference level for measurement. You can change the reference level. (see
"Selecting the Reference Level", page13)
Apply the measuring tool to the point at which you want to start the measurement (e.g.
wall).
Press the button to start the measurement.
Once the measurement process is complete, the laser beam will switch off. For a further
measurement, repeat this process.
Measured values or end results can be added or subtracted.
The measured value typically appears within 0.5s and at the latest after approx. 4s.
The duration of the measurement depends on the distance, the lighting conditions and the
reflective properties of the target surface. Once the measurement process is complete,
the laser beam will automatically switch off.
With a switched-on permanent laser beam and in the continuous measurement function,
the measurement begins immediately after the first press of the button.
The switched-on permanent laser beam is not switched off after the measurement(see
"Permanent Laser Beam ", page16).
The measuring tool must not be moved during a measurement. Therefore, place the
measuring tool, as far as this is possible, against or on a firm stop or supporting sur-
face.
1 609 92A 7E1 | (14.12.2021) Bosch Power Tools